GNX USB Controller (HID-Main)

GNX USB Controller (HID-Main)

• Provides USB connectivity for GNX modules to the PC (by default, GNX modules interconnect via BUS cable to each other and Gladiator NXT, but not directly to the PC)

MS Windows Direct Input allows for only 8 axes per controller.

You’ll need 1x GNX-HID USB controller if there are more than 8 axes in your configuration (and another one if there are more than 2×8=16 axes).

Example: For 8 axes, you do not need any GNX-HID USB controller; however, for 9 to 16 axes you’ll need 1x GNX-HID USB controller, and for 17 to 24 axes you’ll need 2x GNX-HID USB controllers, and so on.

Features

• NJoy32 platform
• 32-bit ARM Controllers inside base and grip
• Plug & Play with Driver-Free Installation (Recommended for Most Users)
• Firmware Upgrade via USB
• Onboard Memory for Storing Profiles
• Optional Programming Software Available (For Advanced Users)
• USB 2.0 HID controller
• Type-C connection

Connectivity

• USB 2.0

Content

• PCB board
• Set of screws
• USB Type-C cable (180 cm / 6′)
• Transparent rubber lens

Warranty:

• 2 Years

Compatible with:

• GNX THQ/V
• GNX FSM-GA
• GNX SEM/V

Instructions:

• VKB Official YouTube Channel

Downloads:

• Please visit the Downloads section for configuration software, device firmware, as well as software documentation.